Brads typically range in length from 5/8-inch up to 1-1/2 inches long.Because of their short length and narrow diameter, they do not have the holding power of larger finish nails or wood screws.
However, some manufacturers are beginning to see the advantages of a cordless brad nailer (which utilizes a combination of a rechargeable battery and a compressed air canister in the tool to provide the power to drive the brad into the wood).
Likewise, until recently, most brad nailers have been of the straight clip variety.
This is to say that the magazine that holds the clips of nails runs square (perpendicular) to the driving cylinder.
While there are many more applications for a finish nailer, a brad nailer is very handy for attaching thin strips and delicate trim.
Keep in mind, though, that brads can be difficult to drive through some hardwoods and manufactured wood products such as plywood or MDF (medium density fiberboard). : Brads used in brad nailers are made from 18-gauge wire, which is considerably thinner than the common 15 and 16-gauge nails for pneumatic or battery-powered finish nailers.
Brads also have a very thin head, which leaves a smaller nail hole after the nail is sunk below the surface of the stock.
This means you'll need to do less hole filling with wood filler before finishing the piece, and in many cases, you may not need to fill the hole at all.
“The Prophet Joseph literally brought heaven closer to earth as he lifted the darkness of apostasy, banished it, and brought to light the Savior’s plain and precious doctrine.
A brad nailer is a smaller version of a standard finish nailer and typically is used for attaching small moldings and trim to a woodworking project.
Because brads are thinner than finish nails, they can often be used in instances where a typical finish nailer might split the piece of trim as the nail is being driven through.
As such, the two tools are generally regarded as complementary, rather than mutually exclusive.